>From what I understand - almost all 1-bar map sensors have very similiar
characteristics. They consist of a pressure-sensitive disc which converts
manifold air pressure into a voltage signal (GM and Chrysler) or a frequency
signal (Ford) for the PCM. Ours turns this pressure into a voltage reading 5-0V
representing 0-100Kpa or 0-20inHg. Its a very linear curve also. You can
verify this by using a hand-held vacuum device like a mity-VAC (or is it
mini-VAC) to map out the voltage -vs- pressure. Only minor level shifting
should be required to match our factory type perfectly. Thats simple enough.
On to the interface w/our throttle bodies. Thats even simpler because it is
functionally only connected via a small vacuum hose. Two screws hold the map
sensor assembly to the throttle body unit but this is not neccessary as long as
the hose connection is intact. In fact - mine has been connected that way (hose
only - no screws) for several years w/no problems.
That only leaves the harness connector - you guys have that one figured out
already right? Didn't someone say they found a source for the factory harness
connectors?
So whats the problem?
Latr,
Shane
"Wisotzkey, Rich" wrote:
> Shane,
> If one can be found with the same parameters, yes you could use it. Course
> then you have to overcome making it compatible with the TB, both on the
> shaft and body mounts.
> Rich - Ashburn, VA
>
> -----Original Message-----
> From: Shane Moseley [mailto:smoseley@ix.netcom.com]
> Sent: Thursday, November 01, 2001 4:49 PM
> To: dakota-truck@buffnet.net
> Subject: DML: Re: vacum
>
> "Wisotzkey, Rich" wrote:
>
> > Hi Bernd,
> > Well, right now it is a small box about 3" long (including connectors),
> > about 1.5" wide, and about .5" thick. I am currently using GM connectors
> on
> >
>
> <snip>
>
> > What does the "MAP Adjuster" look like?
> >
> > - Bernd
>
> Hey guys - how about adding the ability to run a much cheaper alternate map
> sensor?
>
> Thanks,
>
> Shane
>
> --
> '96 IndyRam-HisIndy-MPI TB Pulleys RTcam MPComp HVoilpump
> DynaGearDoubleRoller
> WindageTray CompTAs
> '96 IndyRam-HerIndy-numbered(#142)"Track Truck"
> '74 Triple-Black Dodge Challenger Rallye 360 EFI R&D vehicle
> '93 Dakota LE CC 318 - newest acquisition
-- '96 IndyRam-HisIndy-MPI TB Pulleys RTcam MPComp HVoilpump DynaGearDoubleRoller WindageTray CompTAs '96 IndyRam-HerIndy-numbered(#142)"Track Truck" '74 Triple-Black Dodge Challenger Rallye 360 EFI R&D vehicle '93 Dakota LE CC 318 - newest acquisition
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:27 EDT