Pinion angle

From: Kevin (ksmith10@kornet.net)
Date: Tue Mar 05 2002 - 23:23:30 EST

Next message: Mark Kuzia: "Re: Re: RE: 3.9L rev probleml"
Previous message: Jerry Lee: "Re: RE: 3.9L rev probleml"
Next in thread: Kevin Reimer: "Re: Pinion angle"
Reply: Kevin Reimer: "Re: Pinion angle"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

I have a question for the group. I know pinion angle has been discussed when
lowering a vehicle. I am just curious if it matters on an extended cab with
two piece drive shaft? Essentially the front shaft will always have the
correct angle to the tranny.

Next message: Mark Kuzia: "Re: Re: RE: 3.9L rev probleml"
Previous message: Jerry Lee: "Re: RE: 3.9L rev probleml"
Next in thread: Kevin Reimer: "Re: Pinion angle"
Reply: Kevin Reimer: "Re: Pinion angle"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:07 EDT