YES it still matters. if you drop the rear 2-3 inches you will need at least
6 degrees shim.
----- Original Message -----
From: Kevin <ksmith10@kornet.net>
To: <dakota-truck@buffnet.net>
Sent: Tuesday, March 05, 2002 8:23 PM
Subject: DML: Pinion angle
> I have a question for the group. I know pinion angle has been discussed
when
> lowering a vehicle. I am just curious if it matters on an extended cab
with
> two piece drive shaft? Essentially the front shaft will always have the
> correct angle to the tranny.
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:07 EDT