Fabtech suspension
----- Original Message -----
From: Mike Styer <m_styer@go.com>
To: <dakota-truck@dakota-truck.net>
Sent: Monday, March 25, 2002 7:18 PM
Subject: DML: Gen III 2wd suspension question
>
> Does anyone know what the differences are between the GenIII and GenII
front suspensions on the two wheel drive trucks?
>
> One of my ongoing thought processes is how to raise my 2wd Daktota 5-7"
inches (2-4" taller than a 4x4). The rear supsension is eary enough, but
the front is the tricky part. Seems the only way to lift our 2wd front ends
is to add longer coils or coil spacers, both ways just adding stress to the
front end. Taller spindles would be the best way I can figure, but of
course no one makes any for the GenII's. So I am wondering how different
GenIII parts are from GenII parts? Could one of the lift kits for a GenII
2wd be adapted "relatively" easily to fit a GenII?
>
> Is a straight axle conversion my only way to get the ground clearance I
want and the tough look my girl wants?
>
> Mike S.
> 93 V6 5-speed 2wd
>
> ___________________________________________________
> GO.com Mail
> Get Your Free, Private E-mail at http://mail.go.com
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:13 EDT