Punch,
You need to remove the heat shields (then the JBA wires will fit). They
are also known for holding water, and dirt, and other stuff.
Later,
Tom "Slick"
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of Punch
Sent: Tuesday, April 09, 2002 9:25 AM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: DML: dead truck update
seems the dealer says, the new jba wires, do not fit the sparkplug
housing
(heat shield thingy) as good as mopar does, and allow water and road
debris
to get in there, with nowhere to go but into the engine.
they say my engine was full of water, and flooded, and my oil was
contaminated.
verdict, oil change, new plugs, truck runs $200 CDN!
they also really don't like the wires or the 3923's??
-- ************************************************************************ **** ** 98 Dakota,CC,V6,Amethyst,Homebrew,DynoMax Cat-Back,3923's,Kenwood MP3 Player,BFG-KO's,Accel Ignition Coil, V8 Throttle Body, JBA Power Cables 8.5mm.For Sale: stock air box, K&N drop in filter,
Future Mods: 3.92 LSD, Thunderforms, RT rims/Tires, Fender Flares, JBA headers, IAT Adjuster ************************************************************************ **** **
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:20 EDT