The entire assembly (fan and shroud) measure 24x17. The fan itself is 17 in
diameter. There are 2 flavors out there. The earlier one has the fan
centered, the later one doesn't. I have the earlier version.
They are a 2 speed setup. One ground, 2 hots. Energize one hot - low
speed, energize the other hot - hi speed. The Viper uses 2 relays. One acts
as an on/off, the other takes a feed from the PCM and determines hi or low.
I'm wiring it with a single relay to run high speed only. Based on a temp
sensor, or a manual override switch.
TonyC
-----Original Message-----
From: Ray <bpracing@worldnet.att.net>
To: dakota-truck@dakota-truck.net <dakota-truck@dakota-truck.net>
Date: Friday, May 31, 2002 9:53 PM
Subject: DML: Re: Re: Electric Fan Woes
>
>----- Original Message -----
>From: "TonyC" <acellan1@tampabay.rr.com>
>Subject: DML: Re: Electric Fan Woes
>>
>> Look for a fan out of a Viper. Its a 2 speed HIGH CFM unit. I'm in the
>> middle of swapping one into my 99 RC R/T.
>> TonyC
>
>Tony, could you provide us with the dimensions of that Viper fan? I might
>like to get one for my Dak if it'll fit on a Gen 2. Thanks,
>
>Ray
>http://www.dragtruk.com/ENTRIES/20KM1FD2KWBP.html
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:41 EDT