Thanks for the info, Tony. One more thing.....could you measure the
distance from the radiator to the back (front?) of the fan motor (whatever
is closest to the engine)? I have only about 4" clearance between my
radiator and water pump pulley.
Thanks,
Ray
http://www.dragtruk.com/ENTRIES/20KM1FD2KWBP.html
----- Original Message -----
From: "TonyC" <acellan1@tampabay.rr.com>
To: <dakota-truck@dakota-truck.net>
Sent: Saturday, June 01, 2002 1:58 PM
Subject: DML: Re: Re: Re: Electric Fan Woes
>
> The entire assembly (fan and shroud) measure 24x17. The fan itself is 17
in
> diameter. There are 2 flavors out there. The earlier one has the fan
> centered, the later one doesn't. I have the earlier version.
>
> They are a 2 speed setup. One ground, 2 hots. Energize one hot - low
> speed, energize the other hot - hi speed. The Viper uses 2 relays. One
acts
> as an on/off, the other takes a feed from the PCM and determines hi or
low.
> I'm wiring it with a single relay to run high speed only. Based on a temp
> sensor, or a manual override switch.
>
> TonyC
>
> -----Original Message-----
> From: Ray <bpracing@worldnet.att.net>
> To: dakota-truck@dakota-truck.net <dakota-truck@dakota-truck.net>
> Date: Friday, May 31, 2002 9:53 PM
> Subject: DML: Re: Re: Electric Fan Woes
>
>
> >
> >----- Original Message -----
> >From: "TonyC" <acellan1@tampabay.rr.com>
> >Subject: DML: Re: Electric Fan Woes
> >>
> >> Look for a fan out of a Viper. Its a 2 speed HIGH CFM unit. I'm in
the
> >> middle of swapping one into my 99 RC R/T.
> >> TonyC
> >
> >Tony, could you provide us with the dimensions of that Viper fan? I
might
> >like to get one for my Dak if it'll fit on a Gen 2. Thanks,
> >
> >Ray
> >http://www.dragtruk.com/ENTRIES/20KM1FD2KWBP.html
> >
> >
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:41 EDT