sorry, left out some info on orig post:
i was planning on getting a Fastman TB. if i currently have a 68mm TB, would
it even make sense to go any bigger? or would a simple bore and polish job
justify the cost?
btw, what is the purpose on an "S-bolt"? i have seen it mentioned on
speedtweaks and on fastman's site, but it doesnt really say what the
benefits are.
thanks
-adam
----- Original Message -----
From: "crm" <tb.crm@verizon.net>
To: <dakota-truck@dakota-truck.net>
Sent: Monday, June 10, 2002 11:09 AM
Subject: TB questions...
> hey guys,
>
> when installing my Z tube friday night, i made it a point to check out my
> TB. i had read that some came with 65mm and others with 68mm. i looked on
> the throttle blade and didnt see the numbers i had expected. the only
> visible numbers on the whole thing (without removing it) were right on the
> top:
>
> 53013163AA
> 08010791 HFM
>
> i seem to recall someone saying that the daks with CA emissions (like
mine)
> are equipped with a 65mm, is that correct?
>
> and just to double-check, i should gain low-end with this correct?
>
> thanks again guys!
>
> -adam
> '01 QC 4.7L auto
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:44 EDT