> -----Original Message-----
> From: owner-dakota-truck@dakota-truck.net
> [mailto:owner-dakota-truck@dakota-truck.net]On Behalf Of J McKinney
<snip> While on the dyno we hooked the truck up to an
> OBDII program and at wide open throttle the computer showed that
> the throttle
> body was only 74% open. I checked voltages at the throttle
> postion sensor and
> it showed only 3.8 VDC. It should be 4.8 VDC. I was wondering
> if anybody else
> had ever checked their voltages at wide open throttle.
>
I've checked mine with both a volt meter and a scanner. At WOT mine reads
3.7 VDC and my scanner shows it as 99% open. It reads .6 volts at idle.
I've seen the printouts of runs on a Stock Eliminator Dakota running 12
seconds in the quarter and theirs read 3.something as well. The FSM
indicates the voltage could be as high as 4.8 but I've never seen one read
that high.
Ray
http://www.dragtruk.com/ENTRIES/20KM1FD2KWBP.html
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:05:11 EDT