I don't have the part number but I put MSD Superconductors on last
November. Don't worry about the wire reroute TSB; you won't need it
with these wires. They are cut to *very* exacting lengths and you will
have every wire parallel from the distributor down to the plugs. I can
snag some pictures tonight I think.
Bill wrote:
> I was looking at getting MSD 8.5mm Super Conductor Wire set for my
> truck. The replacement part number as best I can find is PN32189. The
> question I have is, has anybody installed these? I was looking at the
> TSB that addresses re-routing the wires, it looks like they are using
> the stock wires, because some of the lengths look too short and go over
> the valve cover. If I get the PN32189 set from MSD, is it going to be
> the same? I want to get wire loom separators like the ones from "Made
> For You Products" has anyone used these? If I do use them would I have
> to cut custom length wires to make it look neat?
>
> If anyone has done this and has pictures to share, point me to them or
> email me directly with them.
>
> Thanks,
> "Bill Nissley" <bill@nissley.com>
> '98 CC SLT 2x4 5.2L V8 AT, White/Dftwd with custom stripes, 3" lift, ORW
> pre-runner light bar with PIAA 80Pro XT series lights, 32" BFG M/T's,
> Yellow Box Speedo Calib., Flowmaster, Powergate, X-2000 bed cover & K&N
> filter
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:05:12 EDT