I'm running these right now on my 5.9. I don't have the custom wire looms
yet, need them tho, the 8.5mm wires are too big for the factory looms. The
length is fine, and it'll look really good once I get some red looms in
there. I'm not sure what the pn was, I ordered them from Summit, just
looked up the set for a 5.9, $55. Wow, I just checked Summit and the same
set that I bought only a couple months ago, is now $85, ouch.
-- Dave Bensalem, PA '02 R/T RC Flame Red""Bill"" <bill@nissley.com> wrote in message news:000001c23ded$3793ece0$6401a8c0@billnis... > > I was looking at getting MSD 8.5mm Super Conductor Wire set for my > truck. The replacement part number as best I can find is PN32189. The > question I have is, has anybody installed these? I was looking at the > TSB that addresses re-routing the wires, it looks like they are using > the stock wires, because some of the lengths look too short and go over > the valve cover. If I get the PN32189 set from MSD, is it going to be > the same? I want to get wire loom separators like the ones from "Made > For You Products" has anyone used these? If I do use them would I have > to cut custom length wires to make it look neat? > > If anyone has done this and has pictures to share, point me to them or > email me directly with them. > > Thanks, > "Bill Nissley" <bill@nissley.com> > '98 CC SLT 2x4 5.2L V8 AT, White/Dftwd with custom stripes, 3" lift, ORW > pre-runner light bar with PIAA 80Pro XT series lights, 32" BFG M/T's, > Yellow Box Speedo Calib., Flowmaster, Powergate, X-2000 bed cover & K&N > filter > >
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:05:12 EDT