I'll contact Flowkooler and find out what could be causing this on their
pump. Did you happen to notice anything "odd" on the impeller (disc not
tight, etc.)?
- Bernd
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of Rick Barnes
Sent: Monday, August 12, 2002 7:52 AM
To: dakota-truck@dakota-truck.net
Subject: DML: Bernd, Flowkooler continued..
Hey Bernd,
I am sorry I took off out of town just after I told you about my
Flowkooler, but I have just returned. As a matter of maintenance, I was
changing out all my hoses and decided to go ahead and replace the water
pump, and thermostat while I was at it, both items that I bought from
you. While I had it apart, I flushed out the radiator and gently
flushed out the block. Since I have done that, I have noticed that my
engine heats up if it is sitting still which it never did before with
the stock waterpump. I already had a 180 degree t-stat in it though I
replaced it as well. I did not allow it to "peg" , as the temp climbed
while I was sitting in a drive through line, I turned off the a/c,
rolled down the windows and blew the heater, needless to say, I nearly
roasted since it was 95 degrees in Atlanta that day.
Just my experience with the Flowkooler. Like I said, mine does not run
cooler, it runs hotter since I installed that waterpump, and yes, my
thermostat is installed the right way. Rascal
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of Bernd D.
Ratsch
Sent: Monday, August 12, 2002 10:43 AM
To: dakota-truck@dakota-truck.net
Subject: DML: RE: MAP Connector Part Numbers
Rich,
'96 is OBD-II and the older style use a slightly different connector.
'96-'02 are the same though.
- Bernd
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of Wisotzkey,
Rich
Sent: Monday, August 12, 2002 7:27 AM
To: 'dakota-truck@dakota-truck.net'
Subject: DML: MAP Connector Part Numbers
I'm on the MAP connector search again. I still haven't found a source
for these darn things. I would be greatly appreciative to anyone that
will take the time to check their MAP connector on the wiring harness
for part numbers. I have a '96, so I'm guessing that any of the
connectors from around a '94 through a '98 will be the same. Thanks
again! Rich - Ashburn, VA
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:05:13 EDT