Pukeloser@aol.com wrote:
: The plan is to get a tranny (and convertoer) from PATC, that should hold up
: to about 650 horses, the rear will be an 8 3/4 (gotta locate someone that'll
: do the install). I have not yet considered what to do about the drive shaft
: because it is a 2 piece (truck is extended cab), so I imagine I'll have to
: rig a larger carrier bearing and have custom shafts built. The rear shaft
: I'll have done in aluminum but I'm not sure if they ca do an aluminum shaft
: with the front due to the bearing, I'll keep you posted though.
Why not replace it with a one-piece?
---Jon-
.---- Jon Steiger ------ jon@dakota-truck.net or jon@jonsteiger.com -----. | I'm the: AOPA, DoD, EAA, NMA, NRA, SPA, USUA. Rec & UL Pilot - SEL | | '70 Barracuda, '92 Ram 4x4, '96 Dakota, '96 Intruder 1400, '96 FireFly | `----------------------------------------- http://www.jonsteiger.com ----'
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:16 EST