Ron,
You'll probably have to grind a little bit off the side of the support
plate for the Governor Pressure Solenoid (easy to do). Otherwise, make
sure you have new (slightly longer than stock) bolts and you'll be fine.
The conversions to the deep pan only require about 2qts more than
factory. Give me a call if you've got any problems with the install.
- Bernd
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of
ScSilverdak
Sent: Sunday, January 19, 2003 7:57 AM
To: dakota-truck@dakota-truck.net
Subject: DML: Re: Re: Re: Re: Trans-Go shift kit question??
The filter extention and hardware were in the box, along with the pan
and gasket, but no instruction sheet.
Ron-
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:43 EST