A local shop is doing the install for me, the weather here in Pa leaves a
lot to be desired in Jan. so I'm having Karnut's Auto Center install it
while I'm at work .
Ron-
'01 Dakota Sport 3.9 Supercharged
website: http://www.scsilverdak.com
e-mail: scsilverdak@hotmail.com
----- Original Message -----
From: "Bernd D. Ratsch" <bernd@texas.net>
To: <dakota-truck@dakota-truck.net>
Sent: Sunday, January 19, 2003 9:06 AM
Subject: DML: Re: Trans-Go shift kit question??
>
> Ron,
>
> You'll probably have to grind a little bit off the side of the support
> plate for the Governor Pressure Solenoid (easy to do). Otherwise, make
> sure you have new (slightly longer than stock) bolts and you'll be fine.
>
> The conversions to the deep pan only require about 2qts more than
> factory. Give me a call if you've got any problems with the install.
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of
> ScSilverdak
> Sent: Sunday, January 19, 2003 7:57 AM
> To: dakota-truck@dakota-truck.net
> Subject: DML: Re: Re: Re: Re: Trans-Go shift kit question??
>
>
>
> The filter extention and hardware were in the box, along with the pan
> and gasket, but no instruction sheet.
>
> Ron-
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:43 EST