Ken Allgood wrote:
>
> Ok, so I picked up a 2 & 1/4 ton floor jack as well as some 2 ton jack
> stands so I can work on my truck. Well, I cannot get the floor jack to
> lift the load. It will lift up to the point of contact, and you can feel
> some resistance as you should, but it won't lift after that. Release valve
> is turned all the way clockwise. I tried releasing the air in the
> hydraulics as the instructions say (twice actually), but still no go...
> Anyone experience this and have some insight into this??? Thanks!
>
> Ken Allgood
> 97 CC SLT 5.2L (In the garage until I can get it fixed)
lower it all the way down then check the fluid level.
if its full then its probably a reject :(
-- http://www.kencofish.com Ken Arnold, 401-781-9642 Importer/Exporter of Goldfish,Koi,rare Predators Shipping to legal states/countries only! Permalon liners, Oase & Supreme Pondmaster pumpsPlease Note: No trees or animals were harmed in the sending of this contaminant free message We do concede that a signicant number of electrons may have been inconvenienced.
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:44 EST