> Ken Allgood wrote:
> >
> > Ok, so I picked up a 2 & 1/4 ton floor jack as well as some 2 ton jack
> > stands so I can work on my truck. Well, I cannot get the floor jack to
> > lift the load. It will lift up to the point of contact, and you can
feel
> > some resistance as you should, but it won't lift after that. Release
valve
> > is turned all the way clockwise. I tried releasing the air in the
> > hydraulics as the instructions say (twice actually), but still no go...
> > Anyone experience this and have some insight into this??? Thanks!
> >
> > Ken Allgood
> > 97 CC SLT 5.2L (In the garage until I can get it fixed)
>
>
>
> lower it all the way down then check the fluid level.
>
> if its full then its probably a reject :(
>
>
> --
> http://www.kencofish.com Ken Arnold, 401-781-9642
> Importer/Exporter of Goldfish,Koi,rare Predators
> Shipping to legal states/countries only!
> Permalon liners, Oase & Supreme Pondmaster pumps
>
>
> Please Note: No trees or animals were harmed in the
> sending of this contaminant free message We do concede
> that a signicant number of electrons may have been
> inconvenienced.
No, just a knock on wood here. Had to pump it like 10 times before any
pressure would build up, or something like that :-)
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:44 EST