I am gong to be doing the same with mine. I decided that lowering blocks
are the way to go just for an inch but I don't like the aluminum ones. I
did some searching and found that DJM Motorsports carries a set of 1"
steel blocks. I am going to get a set use the eastwood rust stopper and
mount them. Unfortunately the blocks are expensive (which is ridiculous)
at around $80 but I haven't found anything else. If I could find a
really strong set of billet ones I'd go that route instead but no luck.
Jeff Durling
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of
B1LLYW@aol.com
Sent: Tuesday, January 21, 2003 8:47 PM
To: aol@dakota-truck.net
Subject: DML: Lowering Gen II In The Rear
I'd like to drop the rear on my '95 like an inch, to level it out. Any
quick
and dirty solutions out there to do this? I'll even settle for slow and
expensive if I have to.
I have NO experience with lowering trucks, only making them taller.
Bill White - http://www.bionicdodge.com
'02 Dakota QC 4x4, SLT +, 4.7, 5 spd, 3.92 LSD
'95 Dakota CC 4x2, SLT, 318, 5 spd, 3.55 LSD
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:45 EST