check out the audio forum on Dakotausa.com. Someone already did the leg
work for you...I believe it's under infinity amp wiring...or something to
that effect. HTH...
Eric Jerman
>From: Bill Pitz <dakota@billpitz.com>
>Reply-To: dakota-truck@dakota-truck.net
>To: dakota-truck@dakota-truck.net
>Subject: Re: DML: Re: Install new stereo head unit
>Date: Tue, 11 Feb 2003 14:18:18 -0800
>
>
>At 04:13 PM 2/11/2003 -0500, you wrote:
>>Yeah, I was pretty much planning on doing what you propose, but hoping
>>someone else had done the leg-work to figure out which wires are which.
>>I've already installed the head unit and sealed up the dash and didn't
>>want
>>to go back in unless necessary. I have pulled the kick-panel off the
>>passanger
>>side and there are two connectors that run into the bottom of the amp. It
>>looks
>>like one connector is dedicated to what comes from the head unit and the
>>other
>>is mainly the outputs for the speakers. Not sure which is in and which is
>>out.
>>Anyway, if I had the wiring diagram, I was going to rig up some jumpers
>>that I
>>could just run from one connector to another for each speaker connection.
>>That way, if I ever decide to trade in (those quad cabs look mighty
>>nice!), I can
>>just re-plug the factory setup. As you said, it shouldn't be too hard to
>>figure it
>>out. If I get time, I'll do the detective work and report back.
>>
>>Brian
>
>
>If I have time, I'll call Crutchfield and see if they have the wiring key
>for the factory amp..
>
>--
>Bill Pitz <dakota@billpitz.com>
>'00 Dakota CC SLT 4x4
>4.7L V8, 3.92lsd, Flowmaster 50 series
_________________________________________________________________
MSN 8 with e-mail virus protection service: 2 months FREE*
http://join.msn.com/?page=features/virus
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:50 EST