Installing in a freeze plug may be inviting a leak you don't want. I would
use a tee fitting where the factory gauge sending unit is located.
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net]On Behalf Of kc8lbn
Sent: Sunday, February 16, 2003 12:07 PM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: DML: Viper fan Install
I am getting ready to install my viper fan, I am using painless wiring's fan
install harness. Since I don't have a place to install the temp probe I will
be installing it in a freeze plug. What is the best way to install the
fitting into the freeze plug? Should I use a brass plug and a brass adapter?
and if I should how should I put the two togeter? Solder?
Which freeze plug would be the best to use?
Thanks for any time and help provided...
--Jason Bates kc8lbn@attbi.com
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:51 EST