Pop the hood, remove the rubber trim around side of headlamps, now look back
inside at bucket assembly, see the bolts holding the assembly to the body?
10 mm nuts. Or read your owners manual.
----- Original Message -----
From: BARRY OLIVER <DHSPA58@dhs.state.il.us>
To: <dakota-truck@dakota-truck.net>
Sent: Friday, February 28, 2003 8:04 AM
Subject: DML: Re: $^@#$$% headlight
>
> Ok, I am visually challenged, what 10mm bolts? all I see is my
> adjusters...
>
> >>> kwreimer@msn.com 02/25/03 08:00PM >>>
>
> Remove the 10mm bolts you see, I think 3 of them ,now grasp the
> assembly it
> is still attached to this ball socket assembly, no sweat just give her
> a
> good jerk towards you, Pop shes out.
> ----- Original Message -----
> From: BARRY OLIVER <DHSPA58@dhs.state.il.us>
> To: <dakota-truck@dakota-truck.net>
> Sent: Tuesday, February 25, 2003 9:59 AM
> Subject: DML: $^@#$$% headlight
>
>
> >
> > Ok guys, stupid problem of the day. My passenger side headlight
> burned
> out and when I tried to replace it, I couldn't get the @#$%@# grey
> locking
> ring off [gen3] I have tried to the point of hearing plastic crackle,
> but no
> joy. How hard is it to pull the entire headlight assy. out the front?
> It
> looks like I only have to un-do a couple of screws and there seems to
> be a
> track on the bottom that it should slide out of.
> > Plan B, are there any replacement clear headlights [like on the new
> rams]
> out there? If I break this trying to get it out, I might as well
> replace
> both of them with something better if I can get it.. TIA
> >
> >
>
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:45:54 EST