Haven't gotten the truck Line-X'd yet (hopefully about 2 weeks). I'm
considering getting one of those flip-out bed extenders (see
http://www.westinautomotive.com/pages/westin%20bed%20x%20big.html). How
would one go about doing this?
Install the extender, then have the Line-X shop mask over the mounting
plates?
Drill the holes and have the shop "plug" them for the job, then remove
the plugs and I install the plates?
Do nothing, then drill through the Line-X?
Also, am I correct in assuming that the extender comes out really easily
by lifting it to the midway point then pulling it out of the mounting slots?
-- -andyhttp://home.twcny.rr.com/andylevy/ --- andylevy@yahoo.com -------------------------------------------- "Whatever Adam does, do the opposite and you'll be fine" -Bob Tom --------------------------------------------
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:00 EST