Hi,
I have not been to the DML for a while as I have gotten a new mopar toy.
Anyway, I am needing some advice on wheel bearing replacement ASAP. I have
a 97 base model with the 2.5 4 cyl. Obviously a 2wd, with the smaller
brakes. I have a wheel bearing going out on the left front. I hope to be
able to get it swapped out this weekend. Here are my questions:
1. What size is the axle nut?
2. Is the rotor pressed onto the hub?
3. What else needs to be done other than to take off the axle nut and swap
in a new hub/bearing assy?
I plan to put on new rotors and pads while I have it in the air.
Any other suggestions would be greatly appreciated.
Jared
97 Dak
92 Daytona IROC
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:04 EST