Gary,
You can use the front two hood support pins (factory ones with the
rubber stoppers) for the hood pins. On the rear...haven't gone there
yet.
- Bernd
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Gary
Hedlin
Sent: Friday, April 04, 2003 3:47 PM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: DML: Re: Re: garyhedlin.com
Well, I am shocked to see the ammount of feedback I've been getting.
Not only on the DML, but i've recieved 50+ emails so far. Almost all of
them are positive.
The scoop is going back on, trust me. I'm talking with my body guy
about a hood pin setup so that i can swap hoods if i so desire. Just
gonna take some time figuring it out.
The negative emails I've recieved had to do with the other issue I
addressed. I may post them because their SOOO funny. Theyre not even
coherant!! It only goes to show me the type of people that I think are
behind this.
Thanks for Your Support, and Keep On Truckin!!
Gary Hedlin
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:10 EST