Re: RE: RE: My Viper Fan Wiring.

From: Josh Battles (jbattles@bankfinancial.com)
Date: Wed Apr 23 2003 - 09:43:42 EDT


Looks good Bill!!!

--
- Josh
Lowered 2000 Dakota CC 3.9L

""Bill Nissley"" <bill@nissley.com> wrote in message news:000001c30976$9e9b3ab0$6401a8c0@billnis... > > I did the main install of the fan last weekend. As for the wires off of > the fan, the black is ground, the orange and the yellow stripe wires I > believe are interchangeable. It is when they are both active you get the > higher speed. > > The physical installation took quite a bit of time. There was a lot of > fitting/cutting to get it in there. Here is a link to a picture that > shows what I did. > > http://home.attbi.com/~billnis/dakota/viperfan.jpg > The blue is what was cut off the large red arrows identify those areas. > The one arrow in the middle on the right side was a notch I had to make > so the Trans cooler lines could pass through. The green arrows show the > screws that I put in to hold the an angle brace to stiffen the top edge. > To get the brace to go all the way across the top I removed the half > circular area indicated by the arrow at the top. You can see the angle > bracket peeking through at that spot. > > The mounting brackets were fabricated from angle brackets that I got > from Lowes. They mount to the Dakotas factory locations. > > > The clearance to the water pump is shown in this image. > > http://home.attbi.com/~billnis/dakota/fanclearance.jpg > I installed the ASP crank underdrive pulley while I was at it. > > "Bill Nissley" bill@nissley.com KG6ONB > '98 CC SLT 2x4 5.2L V8 AT, White/Dftwd, 3" Fabtech lift, ORI pre-runner > light bar with PIAA 80Pro XT series lights, 32" BFG A/T's, Yellow Box > Speedo Calib., Flowmaster Exhaust, X-2000 bed cover, F/B 50mm Throttle > body, Pro Comp air intake, Viper electric fan, ASP crank pulley, > Roadmaster active suspension & RBW 'LIL Rocker 5th Wheel Hitch. > > > -----Original Message----- > From: owner-dakota-truck@bent.twistedbits.net > [mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Rick > Barnes > Sent: Tuesday, April 22, 2003 2:17 PM > To: dakota-truck@dakota-truck.net > Subject: DML: RE: My Viper Fan Wiring. > > > Bill, do you have your viper fan yet? I received mine today, (along > with my > fender flares, already installed now, looks great). Do you know which > wire > is which? I assume the black is ground. It has a plug that would be > great > to find a connector for else it gets cut off. I think I am just going > to > use the high speed circuit and may put the low speed on a manual switch. > > Rascal > > > > > > > >



This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:12 EST