Thanks Bill
Nice job withthe details and the drawing!
Bob
Bill Nissley wrote:
>Here is what I have:
>
>http://home.attbi.com/~billnis/dakota/viperfan.jpg
>
>The blue is what was cut off the large red arrows identify those areas.
>The one arrow in the middle on the right side was a notch I had to make
>so the Trans cooler lines could pass through. The green arrows show the
>screws that I put in to hold an angle brace that I installed. To get it
>to go all the way across the top I removed the half circular area
>indicated by the arrow at the top. You can see the angle bracket peeking
>through at that spot.
>
>The mounting brackets were fabricated from angle brackets that I got
>from Lowes. They mount the fan to the Dakotas factory locations.
>
>
>http://home.attbi.com/~billnis/dakota/fanclearance.jpg
>
>-Bill
>
>-----Original Message-----
>From: owner-dakota-truck@bent.twistedbits.net
>[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of bob
>Sent: Wednesday, April 30, 2003 7:06 PM
>To: dakota-truck@dakota-truck.net
>Subject: DML: Viper Fan
>
>
>Does anyone have a picture of the fan install, have a part number and a
>cost for the fan?
>
>Thanks
>Bob
>
>
>
>
>
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:17 EST
