why not just install a new resevoir on the side where it is easiest to
install. get a nice billet piece. a lot easier to do the following that it
would be to what you propose!
----- Original Message -----
From: "Gary Hedlin" <ghedlin@theramp.net>
To: <dakota-truck-moderator@bent.twistedbits.net>
Sent: Thursday, May 01, 2003 12:51 AM
Subject: DML: Fan Shroud Swap
>
> Has anyone swapped a 97-99 fan shroud out with a 2000+ shroud?? I'm
looking
> at doing this as my next mod. The reason why I am looking at doing this
is
> since the coolant resivoir is on top of the fan on the 2000+ models, I
could
> use the 2000 shroud, and remove the old coolant resivor....alowing for
more
> air flow in the engine compartment.
>
> Also, since i'm probably doing a viper fan install at the same time, this
> might be a prime time to make the switch.
>
> Any ideas???
>
>
> Gary Hedlin
> President
> Hedlin Web Designs
> http://www.hedlin.net
>
>
>
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:17 EST