Are these relays installed in series or parallel? Sounds like series but I'm just wondering how it can use a 20 amp fuse (don't doubt it, just wondering).
James
In a message dated 5/4/2003 9:23:45 AM Eastern Standard Time, bernd@texas.net writes:
> Something to think about....
>
> The Viper uses two relays for the fan: One general fan relay and the
> other for the Low/High operation. Power wires (from the fusible link)
> to the relay and then to the fan, are 12ga - ground is also a 12ga wire.
> There are two circuits that control the low/high speed:
>
> Circuit C2 - Radiator Fan Relay (ON) ** You can use the adjustable
> permacool/flexalite switch here **
> Circuit C21 - Radiator Fan Low/High Speed ** simple toggle switch on a
> relay **
>
> The power runs through both relays under Low or High-Speed operation.
>
> BTW: The Fuse used on the Viper is a 20A fuse
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf
> Of TJG
> Sent: Sunday, May 04, 2003 9:56 AM
> To: dakota-truck@dakota-truck.net
> Subject: DML: Re: Viper Fan question
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:18 EST