Fuel pump maybe?
Rascal
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of
DodgeBoyz3@aol.com
Sent: Saturday, May 10, 2003 10:38 PM
To: dml@dakota-truck.net
Subject: DML: Gen II won't idle
Howdy all,
Been awhile since I have posted. Tried calling a few in the know people for
advice and I myself am a fair mechanic, but to no avail. Truck can only be
started with your foot to the floor (sometimes....when it is cold it seems
to start easier), it will not idle and will die each time you put it in
gear. You have to rev it up full blast and shif it into gear to get it to
go.....not good!
None of the following changes have cured the problem.
1. Swap out TPS with new unit
2. Replaced IAS with new unit
3. Swapped out MP computer for stock one
4. Cleaned T-Body (B&F Stage II)
5. Checked all vacum hoses and electrical connections
6. Replace ignition coil
7. Checked all SP wires and plugs
8. Replace upper rad hose (found a leak)
It throws the following codes: 12, 22, 37, 55. But I don't see how any of
them affect the idle circuit. Check engine light is on.
TIA for the feedback!
What am I missing here?
Gene Rivers
95 SLT 5.2L RC SB CRPC............147,000K
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:19 EST