Re: Tonneau

From: H62300@aol.com
Date: Wed Jun 11 2003 - 11:55:46 EDT


In a message dated 6/10/03 9:48:33 PM Pacific Daylight Time,
dakota@billpitz.com writes:

> Subj: Re: DML: Tonneau
> Date: 6/10/03 9:48:33 PM Pacific Daylight Time
> From: <A HREF="mailto:dakota@billpitz.com">dakota@billpitz.com</A>
> Reply-to: <A HREF="mailto:dakota-truck@dakota-truck.net">dakota-truck@dakota-truck.net</A>
> To: <A HREF="mailto:dakota-truck-moderator@bent.twistedbits.net">dakota-truck-moderator@bent.twistedbits.net</A>
> Sent from the Internet
>
>
>
>
> On Tue, 10 Jun 2003 22:51:27 -0400, kerib@ptd.net ("Tom Byrne") wrote:
>
> >
> >Does anyone know of a tonneau that I can make work with my Shelby
> >w/lightbar?
> >Tom Byrne
> >84 Charger 2.2 FSP
> >89 Shelby Dakota #233
> >99 Neon DOHC DSP
> >The inherent vice of capitalism is the unequal sharing of blessings; the
> >inherent vice of socialism is the equal sharing of miseries. - Winston
> >Churchill. ...
>
> Extang and a couple of the other manufacturers make some soft tonneaus
> that are designed to work with toolboxes in the bed. You might check
> with them and see if you can either adapt one of those or have
> something custom made. Doesn't seem like it would be too terribly
> difficult to make work.
>
> -Bill
>
   I might have a new tonneau that fits the Shelby. I used to have one and I
did buy a extra one when I bought my truck. It Has velcro on the one side.
It is made to go around the light bar. You would have to fabricate metal plates
to go under the light bar so the tonneau could be stuck down where it goes
around the light bar. E mail me off list if you have any more questions.

        Thanks Brian



This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:27 EST