Most shops can turn them with the standard brake lathes. HOWEVER, they
should not grind down more than .010" at a time...preferably .005" each run.
I just redid mine a few months ago on the brake lathe at the dealership.
- Bernd
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Mallett,
Donald B
Sent: Wednesday, November 05, 2003 8:45 PM
To: '.DML'
Subject: DML: Turning PowerSlot Rotors? (was Caliper spring)
Funny you mentioned that, My Raybesto pads are due for a change, and
PowerSlot rotors turned. They were installed on July, 7 2000 and 25760 miles
ago. Its the driver side, outside pad that is the worst of them all.
Can any shop turn the PowerSlot rotors? If not who can?
*-------------------------------Y2KOTA-------------------------------*
Don Mallett
Y2K QC 4.7L Auto SLT+ 4x2
http://www.y2kota.us
*-------------Straight home & no playing in the puddles!-------------*
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:07 EST