"Michael Maskalans" <dml@tepidcola.com> wrote in message
>
> they're the right threads, but 1/4" instead of 7mm. I thought that was
> pretty strange. and they were the only set of pins in a >30 mile radius
> - no one had any except the shop that had one set. of course that was
> the same shop that had sold me pads without springs earlier that
> morning.....
I just re-used my old springs. Are you supposed to replace them every time?
Or, were you talking about the springs that hold the pads into the calipers
and not the spring that goes on the outside of the caliper to hold it in
place against the spindle?
-- - Josh Lowered 2000 Dakota CC 3.9L www.geocities.com/lenny187/dakota.html
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:12 EST