I would be worried about the power being too much if I were running it in 4
wheel drive, but Im not. There wont be any power applied to the chain,
synchros or front output shaft at all. Unless is there something else I
should worry about?
TJ
----- Original Message -----
From: "Ronald Taylor" <scsilverdakdml@hotmail.com>
To: <dakota-truck@dakota-truck.net>
Sent: Saturday, May 01, 2004 9:30 AM
Subject: RE: DML: Re: Loss of bottom end, completely....
>
> My 4x4 is about .5-.7 seconds slower in the qtr due to driveline
differences
> than it should be......
>
> My engine package is very close to Bernd's before he built the new engine
> and our trucks are close in weight 2wd CC VS 4wd RC, he is running about
> .5-.7 seconds faster than I am..
>
> Trying to push a 4x4 thru the qtr is a lot harder than a 2wd, you also run
> the risk of transfer case damage if too much power is run thru the tranny
> and the transfer case.
>
> just my .02 cents worth....
>
> Ron
> 01' Dakota Sport 3.9 4WD
> http://www.scsilverdak.1colony.com
>
> _________________________________________________________________
> Mother's Day is May 9. Make it special with great ideas from the Mother's
> Day Guide! http://special.msn.com/network/04mothersday.armx
>
This archive was generated by hypermail 2b29 : Tue Jun 01 2004 - 10:59:11 EDT