Re: tune up parts

From: andy levy (andy-dml@levyclan.us)
Date: Sun May 16 2004 - 10:49:35 EDT

Next message: greg conner: "RE: Re: AAR Fiberglass at Shows?"
Previous message: Bob Tom: "Re: backfire through intake question"
In reply to: ffastje: "tune up parts"
Next in thread: DAKSY: "Re: tune up parts"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

ffastje wrote:
> I'm looking for a good reasonably priced cap and rotor and a set of wires.
> So much is out there looking for recommendations.

NAPA's all-brass cap & rotor (made be Echlin IIRC) are the hot ticket
'round here.

Wires...I went MSD 8.5mm on my 318 but they're a bit spendy.

Next message: greg conner: "RE: Re: AAR Fiberglass at Shows?"
Previous message: Bob Tom: "Re: backfire through intake question"
In reply to: ffastje: "tune up parts"
Next in thread: DAKSY: "Re: tune up parts"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Tue Jun 01 2004 - 10:59:12 EDT