Re: RE: Deep electronic question..

From: Don (y2kota@y2kota.us)
Date: Fri Jun 18 2004 - 17:01:23 EDT


I looked at the Cruse Control & PCM. Its not a simple on off at 30mph.
I was hoping for something there.

Don

On Friday, June 18, 2004, at 11:31 AM, Wayne Allewelt wrote:

>
> Don,
>
> You might want to check the wires going to the cruise control. My 01
> FSM
> says "The system is designed to operate at speeds above 30 mph (50
> km/h)."
> "The speed control system is electronically controlled and vacuum
> operated.
> Electronic control of the speed control system is integrated into the
> Powertrain Control Module (PCM)."
>
> If the speed control system in electronically controlled by the PCM it
> might
> not allow power to the cruise control system below the 30 mph mark. I
> would
> begin with the wires that lead to the cruise control switches for
> power. Of
> course this will involve checking for voltage while the truck is
> moving.
> Sounds like fun. :)
>
> Wayne
> 01 QC Sport 4x4 V8
> East Central Florida
>
> -----Original Message-----
> From: Don
>
> I'm looking for a 12v or 5v signal that drops or picks up at 25mph to
> 40 mph
> and stays there until the speed drops below that point again. In
> addition to
> the info in my sig. The Dak has cruise control, A/C, 45-RFE, 4.7L,
> keyless
> door entry, 4*2 and over head console. I believe that's all the extra
> that
> deal with the electronics.
>
>
>
>



This archive was generated by hypermail 2b29 : Thu Jul 01 2004 - 00:15:17 EDT