The only issue is that the 99 does not have bolts holding the pulley to the
water pump shaft, it's pressed on and the new water pump was of the same
design.
Thanks for the response,
Dave Clement
99 SLT+ CC 4x4
In article <ccknmt$7o0$1@bent.twistedbits.net>, d.schultz@sympatico.ca writes:
>
>
> Hi:
> Here is what my FSM says for my '98 model.
>
> VISCOUS FAN/DRIVE—3.9L/5.2L/5.9L ENGINES
> REMOVAL
> (1) Disconnect battery negative cable.
> (2) The thermal viscous fan drive/fan blade assembly is attached (threaded)
to
> water pump hub shaft. Remove fan blade/viscous fan drive assembly from water
> pump by turning mounting nut counterclockwise as viewed from front. Threads
on
> viscous fan drive are RIGHT HAND. A Snap-On 36 MM Fan Wrench (number SP346
from
> Snap-On Cummins Diesel Tool Set number 2O17DSP) can be used. Place a bar or
> screwdriver between water pump pulley bolts to prevent pulley from rotating.
This archive was generated by hypermail 2b29 : Sun Aug 01 2004 - 00:46:14 EDT