Torx bit #10 or #15 to remove the sensors from the TB. Nothing special
about removing either. Be nice to the little rubber elbow to the MAP so you
don't crack it.
TonyC
-----Original Message-----
From: Jay & Dana <jay&dana@telus.net>
To: DML <dakota-truck@dakota-truck.net>
Date: Tuesday, July 27, 2004 8:37 PM
Subject: DML: Thanks for all the advice
>
>To all those that responded to my recent questions about the TB, IAT, and 5
>speed bucking, thanks for your help, much appreciated.
>One last question though :-)
>Since this will be the first time I've taken the TB off my 97, 318 Dak is
>there anything I should know when removing the MAP & TPS sensors, such as
>will wires and springs fling out at me? Do these sensors have gaskets and
>if so can I use the original ones or purchase new ones? I know all the IAC
>sensor needs is to replace the rubber o-ring (and be careful when cleaning)
>and I already have a new TB gasket.
>
>Again thanks for all your help,
>Jay
>
>
>
>
>
This archive was generated by hypermail 2b29 : Sun Aug 01 2004 - 00:46:15 EDT