Hey, Mike...
<snip> and I'm on the smaller end of things. I was thinking something like
a
very strong 4-way spanner bit. is that what these are?<snip>
Yeah, you'll prolly have minimal luck with the E-Z-Out at that size...They
fit
in the tee type tap handle & have 4 tangs that extend into the tap
flutes...IF
you can get the tap freed up, the E-Z-Out will turn it out, but they're not
ballsy
enuff to do the freeing-up part...
You might try applying heat to the surrounding surface...it may expand at a
faster rate than the tap's remnants...
Last resort? Burn it out with your torch! (Yeah baybeee!) then glob some
weld
on there, grind it flat & drill & tap!
Later...gotta go install a coupla fireplaces...
Bob Smith (DAKSY2K on AIM)
Averill Park, NY
2K DAK SY CC Sport + V6 4X4 5 Speed
WebPage URL: http://home.nycap.rr.com/daksy/
This archive was generated by hypermail 2b29 : Wed Sep 01 2004 - 00:53:41 EDT