> > For my 99 2WD, the FSM says to use the spring compressor tool to
> > be able to release the lower all joint from the knuckle.
> >
> > Since i'll have the truck up on stands at the frame, wouldn't i
> > be able to just use a floor jack to push the lower control arm
> > up enough?
> >
> > I realize i could make a tool like in the manual, but am hoping
> > the tool is just a convenience.
> When I did my joints, I supported the truck by the frame with
> jackstands, then used a floor jack to support the lower arms and
> keep the springs compressed. It was really no big deal at all.
Ok, thanks. I just wanted to make sure. Often when the FSM says
something that's different than what i would do, there's some subtle
reason.
I might have a bad ball joint as well as the bad bushings, so i
may end up removing the entire arm....
eric
-- 1974 Valiant 4-door, 318 1999 Dakota Ext Cab, 2WD
This archive was generated by hypermail 2b29 : Sat Jan 01 2005 - 11:48:09 EST