Thank you.. If I can get home from work tomorrow before dark.. I'll try and
get out back and see if how many still match.
Aaron
----- Original Message -----
From: <jon@dakota-truck.net>
To: <dakota-truck-moderator@bent.twistedbits.net>
Sent: Monday, February 14, 2005 11:32 AM
Subject: Re: DML: Gen II wiring question
>
> "Aaron Wyse" <awyse@sw.rr.com> wrote:
>
> : Is there someone out there that can check a FSM for the wiring at the
fuel
> : pump?
> : There's a 5 wire connector at the pump.. and I need to know which wire
is
> : which..
> : First.. so I can turn on the pump to transfer the fuel out of the tank
> : (easier than a funnel) and second.. so I can help determine if I'll be
able
> : to use it as a second tank for my Dak after the engine swap & body lift,
or
> : if it'll end up in my RamCharger as a reserve tank (for a 50Gal total)
>
>
> Here's what my '96 FSM has - I don't know if it will help at all, this
> is a 6 wire connection. But maybe the wire colors will be the same and
> might be somewhat useful...
>
> As you look at the connector with the tang at the left side, the pins
> are situated as follows:
>
>
> ---------
> | 1 |
> | 4 |
> | 2 |
> | 5 |
> | 3 |
> | 6 |
> ---------
>
>
> Pin Wire color Function
> --- ---------- --------
> 1 Dark Green w/Black stripe ASD relay output
> 2 Light Blue w/Black stripe Fuel monitor output signal
> 3 Dark Blue w/Yellow stripe Fuel level sensor signal
> 4 Black w/White stripe Ground
> 5 Black w/Light Blue stripe Sensor ground
> 6 Black Ground
>
>
> Hope that helps - good luck!
>
>
> --
> -Jon-
>
> .-- Jon Steiger ---- jon@dakota-truck.net or jon@jonsteiger.com --.
> | 1970 Barracuda - 1990 Dakota 'vert - 1992 Ram 4x4 - 1996 Dakota |
> | 1996 Intruder 1400 - 1996 Kolb FireFly - 2001 Ram QC 3500 CTD |
> `------------------------------------ http://www.jonsteiger.com --'
>
This archive was generated by hypermail 2b29 : Tue Mar 01 2005 - 10:04:31 EST