"Aaron Wyse" <awyse@sw.rr.com> wrote:
: Is there someone out there that can check a FSM for the wiring at the fuel
: pump?
: There's a 5 wire connector at the pump.. and I need to know which wire is
: which..
: First.. so I can turn on the pump to transfer the fuel out of the tank
: (easier than a funnel) and second.. so I can help determine if I'll be able
: to use it as a second tank for my Dak after the engine swap & body lift, or
: if it'll end up in my RamCharger as a reserve tank (for a 50Gal total)
Here's what my '96 FSM has - I don't know if it will help at all, this
is a 6 wire connection. But maybe the wire colors will be the same and
might be somewhat useful...
As you look at the connector with the tang at the left side, the pins
are situated as follows:
---------
| 1 |
| 4 |
| 2 |
| 5 |
| 3 |
| 6 |
---------
Pin Wire color Function
--- ---------- --------
1 Dark Green w/Black stripe ASD relay output
2 Light Blue w/Black stripe Fuel monitor output signal
3 Dark Blue w/Yellow stripe Fuel level sensor signal
4 Black w/White stripe Ground
5 Black w/Light Blue stripe Sensor ground
6 Black Ground
Hope that helps - good luck!
--
-Jon-
.-- Jon Steiger ---- jon@dakota-truck.net or jon@jonsteiger.com --.
| 1970 Barracuda - 1990 Dakota 'vert - 1992 Ram 4x4 - 1996 Dakota |
| 1996 Intruder 1400 - 1996 Kolb FireFly - 2001 Ram QC 3500 CTD |
`------------------------------------ http://www.jonsteiger.com --'
This archive was generated by hypermail 2b29 : Tue Mar 01 2005 - 10:04:31 EST