Re: Re: caliper mounting pin wrench size?

From: jon@dakota-truck.net
Date: Fri Jul 15 2005 - 00:44:57 EDT


"DAKSY" <rsmith13@nycap.rr.com> wrote:

:>Hey, Jon...

: <snip> I'll second that (assuming you can find one of course - pickings
: were mighty slim around my parts when I went looking for 7mm stuff).
: It will take you a little while with a regular allen wrench since
: you can only give it about a quarter turn at a time. It is most
: certainly doable with a regular allen wrench, but a socket wrench
: would sure speed things up.<snip>

: I grabbed a whole set of em (3mm-10mm) mounted on one of those little bars
: with the retainer spring clips for my 3/8 drive socket. I'm pretty sure I
: got em at NAPA...Not sure of the $$$$ - 'twas a coupla years ago...

    Sounds pretty nice, I'll have to keep an eye open for something like
that.

: BTW, Susan & I will hafta pass on the BBQ. DAKSY needs new sneaks & the $$$
: are a tad short this month,

  Bummer! :-( I'm sorry to hear that, the BBQ won't be quite the
same without the bright yellow beast. :-) (Then again, maybe its
for the best - with the dry spell we've had lately, your paint job
could very well ignite forest fires.) ;-) Well, hopefully we'll
see you and Susan next year in Denver, or possibly at Daktoberfest
(whenever that is).

-- 
                                          -Jon-

.-- Jon Steiger ---- jon@dakota-truck.net or jon@jonsteiger.com --. | 1970 Barracuda - 1990 Dakota 'vert - 1992 Ram 4x4 - 1996 Dakota | | 1996 Intruder 1400 - 1996 Kolb FireFly - 2001 Ram QC 3500 CTD | `------------------------------------ http://www.jonsteiger.com --'



This archive was generated by hypermail 2b29 : Mon Aug 01 2005 - 10:56:27 EDT