I was just planning a whole axle assembly swap just so I wouldn't have to
mess with setting the backlash and mesh. Still deciding if I want to do
this. Are there aftermarket posi units that will bolt it? That is the one
thing I kick myself over not ordering on the truck.
-Joe
>
> BTW, I wasn't sure from your post wether you were planning
> to just pull the gears and sure grip out of an axle or simply
> swap the entire axle into your truck. If its the former,
> you'll need to make sure the gears are set up and shimmed
> properly for the required amount of mesh and backlash. If you
> aren't familiar with the process, you'll need a good manual,
> some tools like a dial indicator and some patience, or a mechanic
> to do the install for you.
>
> Good luck in your search!
>
This archive was generated by hypermail 2b29 : Thu Dec 01 2005 - 10:10:44 EST