Does anyone have a spec for Distributor Drive Gear Backlash?
I measured about 5 degrees of movement when turning the distributor drive shaft by hand.
( This is about 3mm of movement if you look at the tip of the rotor when its on the
shaft. And I made sure the rotor fit snuggly on the shaft. ;-) )
-dan k
Dan K.
'92 Grey Dak CC, 318, 4x2, 46RH, 3.55 rear, 235/75R15, PS, PW, PB, PL, AC.
Mods: Cool air, K&N oil/air, 180* T-Stat, Autolite 3924s, re-located IAT, Trans-Go shift kit.
Future: Swap motor for a slightly modified Magnum 5.9L engine.
__________________________________
Yahoo! FareChase: Search multiple travel sites in one click.
http://farechase.yahoo.com
This archive was generated by hypermail 2b29 : Thu Dec 01 2005 - 10:10:44 EST