Hey, Bernd...
<> If you can...and if you have enough room, you can cut/solder/heat shrink
the
sensor wires. <>
I'll take a peek at it later to see if that's feasible...
<>However, if this is on the sensor side of the connector, just
replace the sensor - it comes with a new harness anyway.<>
Not sure what you mean there... The wiring in question is on the harness
side - above the (molex?) connector, right at the entry point
on top of the block . Looks like the sensor is attached to the bakelite
plate under the distributor cap. The harness looks like it's wrapped, so I
can't tell which way it goes, but, again, I'll take a peek.
THX
Bob (DAKSY) Smith
DAKSY2K on AIM
2K SY Dakota Sport +
V-6 4 x 4 5 speed
2K05 HD 883C YP
http://home.nycap.rr.com/daksy/
Averill Park, NY
This archive was generated by hypermail 2b29 : Mon May 07 2007 - 19:04:36 EDT