Re: Re: Challenge: Identify the part?

From: David Gersic (info@zaccaria-pinball.com)
Date: Mon May 07 2007 - 01:33:30 EDT

Next message: Don Rey: "Re: News"
Previous message: Terrible Tom: "How NOT to recover a rolled 4x4..."
In reply to: DAKSY: "Re: Challenge: Identify the part?"
Next in thread: Phil Jenkins: "Re: Challenge: Identify the part?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

On Sunday 06 May 2007 10:05 pm, DAKSY wrote:
> When I did the rear brakes on the DAKSY, I hadda press fit the pin into the
> shoe with a large C-clamp...If you got new pins with the spring kit, I'm
> pretty sure they're a tight fit...

Yes, the kit came with new pins as well. Thanks for the info. I'll make sure
they're in tight. I'd hate to screw up the new parts.

Next message: Don Rey: "Re: News"
Previous message: Terrible Tom: "How NOT to recover a rolled 4x4..."
In reply to: DAKSY: "Re: Challenge: Identify the part?"
Next in thread: Phil Jenkins: "Re: Challenge: Identify the part?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 01 2007 - 09:06:10 EDT