Re: Challenge: Identify the part?

• Next message: Terrible Tom: "How NOT to recover a rolled 4x4..."
• Previous message: Barry Oliver: "Re: was: gas tank now K&N FIPK"
• In reply to: David Gersic: "Challenge: Identify the part?"
• Next in thread: David Gersic: "Re: Re: Challenge: Identify the part?"
• Reply: David Gersic: "Re: Re: Challenge: Identify the part?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hey, David...

<> What's supposed to keep the pin from leaving the backing plate, though?
There
 doesn't seem to be any kind of retainer clip or anything. Does it just get
 held there by the spring tension?<>

When I did the rear brakes on the DAKSY, I hadda press fit the pin into the
shoe with a large C-clamp...If you got new pins with the spring kit, I'm
pretty sure they're a tight fit...
HTH,

Bob (DAKSY) Smith
DAKSY2K on AIM
2K SY Dakota Sport +
V-6 4 x 4 5 speed
2K05 HD 883C YP

http://home.nycap.rr.com/daksy/
Averill Park, NY

• Next message: Terrible Tom: "How NOT to recover a rolled 4x4..."
• Previous message: Barry Oliver: "Re: was: gas tank now K&N FIPK"
• In reply to: David Gersic: "Challenge: Identify the part?"
• Next in thread: David Gersic: "Re: Re: Challenge: Identify the part?"
• Reply: David Gersic: "Re: Re: Challenge: Identify the part?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 01 2007 - 09:06:10 EDT