Hey gang...got a question that I know has been answered here before, but I
didn't give it much attention, because at the time it didn't apply to me.
Here's my situation... I stripped out one of the front slider bolt threads
from the steering knuckle, enough to not trust them. Can't seem to determine
the "right" thread pitch with what I have. It seems to be a 10mmX1.5. Can
someone confirm the correct thread pattern for me ?? Will probably have to
helicoil it, but I still need to know which kit to buy to even do that. Even
some of the SAE dies seem "close", but just not quite it. I know I'm not the
first, nor will I be the last. Thanks for your help !!
Eric Luce
'99 Dak SLT, CC
5.2L, 2WD, auto
This archive was generated by hypermail 2b29 : Fri Jun 01 2007 - 09:06:10 EDT