Zito, James A (GE Infra, Energy) wrote:
> Ok folks '03 3.9 Dak.... Al intake, steel floor that is all oily AGAIN......
>
> Has anyone after market come up with the obvious solution to this problem.....
>
> Mill a bottom for the intake out of the same Al as the rest of the F'ing intake and bolt it up???????
>
>
> If not anyone know the alloy the intake is made from???
>
> Jim
> even with it suckng harder than ever b4 with new plugs it's
> closer than ever to 20 on the highway................
>
Well if you had a V8, I would say throw an M1 intake manifold on there
and be done with it. The belly pan gasket is blown on my Ram, and thats
my once-in-for-all solution.
Since you have the long since aftermarket-ignored 3.9V6 - pull the
intake, and use a bead of The Right Stuff gasket material between the
pan and the upper manifold. That stuff should be the last time you will
have to regasket the belly pan.
-- ------------------------------------------------------------ The Zen philosopher Smasho once wrote: "A truck with no dents, is not a 4x4... and a 4x4 with no dents wasn't at a DML BBQ" ------------------------------------------------------------ three busted-ass daks, a gas hog, and a rollerskate http://members.aol.com/silvereightynine/ AIM & Yahoo: SilverEightynine ------------------------------------------------------------
This archive was generated by hypermail 2b29 : Fri Jun 01 2007 - 09:06:10 EDT