Back in the day there was an offering of a 1/4" Al plate, although I
forget who was offering it. I simply went down to a local steel fab
shop with the stock bellypan and had an Aluminum plate made for it.
IIRC, it cost around $75 to have made.
-Jon Smith
>
>> Ok folks '03 3.9 Dak.... Al intake, steel floor that is all oily
>> AGAIN......
>>
>> Has anyone after market come up with the obvious solution to this
>> problem.....
>>
>> Mill a bottom for the intake out of the same Al as the rest of the
>> F'ing intake and bolt it up???????
>>
>>
>> If not anyone know the alloy the intake is made from???
>>
>> Jim
>> even with it suckng harder than ever b4 with new plugs it's closer
>> than ever to 20 on the highway................
>>
This archive was generated by hypermail 2b29 : Fri Jun 01 2007 - 09:06:10 EDT